Elevator Support Tennessee elevator maintenance Tennessee Household Lifts Tennessee

Ruth Attig, a special education classroom aide in Murphysboro Middle School, at Tennessee went to the school first on Friday to observe employees of Phoenix Modular Elevator and Fager-McGee Commercial Construction set up a new lift at the school.
"I only wanted to see them do it if I have to use the lifts this year," Attig stated.
Attig, who's worked in the area for 31 years and been at the middle school as 1993, had been stuck at the old elevator with students several times.
The shaft and elevator parts are pre fabricated.
"We make sure they are there and ship them all over the nation and Canada. This one is in our own backyard," Allgaier said.
Many times, elevators produced by Phoenix Modular have been installed on the outside buildings. The elevator at the faculty is entirely inside the construction.
Lynndi Kesler, sales manager at Phoenix Modular Elevator, said the lift was assembled of tube steel along with standard drywall. It weighs approximately 25,000 pounds.
"It has built no different compared to a stick-built elevator," said John Holmes, quality control director.
The shaft and lift assembly has been loaded onto a flat bed truck and brought to Murphysboro Friday morning.
Considering rain storms were expected Thursday day , workers from Fager-McGee slice the gap in the faculty ceiling Friday morning, according to Yeyo Granados, vice president of construction to Fager-McGee. They sent a rep to Phoenix Modular Elevator earlier in the day in the week to take measurements of this elevator. (The rest of the openings to the shaft were cut before.)
After the truck with all the elevator arrived, two cranes picked the assembly, turned it vertical and sat down it on a lawn while straps out of the smaller studs had been removed. The larger crane picked the elevator up and slowly lowered it floors. It will soon be bolted and welded check here into place.


The hydraulics and electric wiring will be installed, and then the lift will be analyzed and inspected.
"We're simply happy the rain stopped," Allgaier stated.

Chris Grode, superintendent of Murphysboro Community Unit School District 186, in

Tennessee said dealing with Phoenix Modular Elevator stored the district considerably a lot more than with the elevator assembled onsite. The initial quote for replacing the old elevator was 500,000. Total cost for your own elevator that's being installed is just a lot more than $300,000.
"That is a high-tech job for this particular area," Granados said.
The project had been funded with the county centers sales taxa county ballot initiative that passed November 2016.
"The most fantastic thing about here could be that the sales tax goes to local companies," Grode said.


The lift also meets requirements of the Americans with Disabilities Act.
Grode explained the school office also is being transferred during summer time renovations. The new elevator and also the front door will open directly into the workplace, improving security at the faculty.
What will occur to the old lift? Grode said it will probably be welded closed after the new lift is operational.
Murphysboro Middle School is situated at 2125 Spruce St. Murphysboro Tennessee

Leave a Reply

Your email address will not be published. Required fields are marked *